xcluma MAX7219 Microcontroller 4 in 1 Display with 5P Line Dot Matrix Module
₹521.00
- A single module can drive a 8×8 dot matrix common cathode Operating Voltage: 5V
- Dimensions: 12.8X12.8X1.3cm Fixing screws with 64 holes with a diameter 3mm
- Module with input and output interfaces, support for cascading multiple modules Quality:1Set
- The left side of the module to the input port, the right to an output port When the control of a single module, simply input port connected to CPU When a plurality of cascaded modules, input and output termination CPU, an input terminal of the second output end of the first module a module, the first two modules of the input terminal of the three termination modules, and so on… 51 microcontrollers, for example: VCC 5V GND GND DIN P2.2 CS P2.1 CLK P2.0
,
Specification: xcluma MAX7219 Microcontroller 4 in 1 Display with 5P Line Dot Matrix Module
|
8 reviews for xcluma MAX7219 Microcontroller 4 in 1 Display with 5P Line Dot Matrix Module
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review
Related Products
xcluma MAX7219 Microcontroller 4 in 1 Display with 5P Line Dot Matrix Module
₹521.00
krishnamurthy m bhat –
Nice ing good
Simon Mandy –
This so cheap and poor in quality. Never buy this product. This product does not have return policy. Before this product i have worked on many DMD display like 32×16, 8x8x4 but This single module of 8x8x4 so much of current that your Arduino will get damage. You need to put external power supply but make sure it will again consume more current so your Arduino board will start heating up. Buy at your own risk. I personally prefer not buy this DMD display. Very poor…. disappointment 🙁 wasted my Rs. 660
Sandeep –
Excellent led dot matrix display for projects.
It’s adequately bright.
Used it to make a live YouTube subscriber counter using esp8266 module.
Been using continuously for 2 weeks and no issues.
bnnp –
At first I was quite disappointed that I bought this despite of a lot of negative reviews but thanks to a few users who had left not only positive reviews but also the exact specs to use. I used the MD_Parola library and replaced the Parola_HW with FC16_HW and it worked !
Simon Mandy –
This product was good for quite few days but then started showing problems … Ome of the LED’s went out … This is quite good for prototype but not recommended for stable versions.
Antriksh –
Works as intended. The usual issue with this 4-in-1 unit may be the use of library and code examples meant for different hardware. This may appear like four consecutive FC-16 units but it’s a different hardware. Use Parola library with the following constructor:
MD_MAX72XX::ICSTATION_HW
#define MAX_DEVICES 4
Make note of ‘4’ for max devices, since these are 4 individual units.
ARUNESH RAJPUT –
ARUNESH RAJPUT –
I intended to make a simple clock. So got two of these and set it up with ESP8266 to get a 16×32 size display. The double size make it a great addition to the room and visibility during day and night is great.